1. <pre id="eawpq"></pre>
    <acronym id="eawpq"><label id="eawpq"></label></acronym>

      Ceramic frit raw material mixing tips

      2018-05-17 16:09:49 admin 1060
      The principle of mixing ceramic frit raw materials is only one, that is, full mixing, the following Xiaobian to introduce the two points that need special attention when mixing raw materials:
           1. Adding sequence when the raw material and refractory raw material are mixed: The refractory raw material (such as quartz, zircon sand, etc.) should be moistened with a small amount of water first, and then the fluxing raw material (such as borax, red lead, potassium nitrate, etc.) should be added. Stir, mix, sifted, and finally add other raw materials to fully mix evenly to ensure that the surface of the refractory material is fully enveloped by the flux, and the fused surface of the refractory material is formed at a relatively low temperature to achieve rapid and complete melting.
           2. The method or sequence of adding less than 3 to 5 wt% of the material. In the dry blending process, each ingredient is added one by one when compounded. It will produce wet agglomerates or local relative concentration, resulting in non-uniform mixing, and the proportion will decrease, resulting in greater error.
           The above information about ceramic frit is introduced here today. Thank you all for reading. If you have any need, please contact us.
      • Good life plan

      • Smart toilet
      • Rock board home life
        Scan QR code to access mobile

      BoTest 陶瓷網 武漢理工大學 vbglaze

      Copyright (c) 2002-2021 Zibo juncera Ceramic Material Co., Ltd. All rights reserved. 魯ICP備19003072號-1 E-mail Technical Support:YUYISTUDIO

      99大乳捏奶头揉在线观看91_久久AV无码专区AV桃花岛_日韩成人免费电影 在线播放_爆乳白丝护士自慰喷水图片
      1. <pre id="eawpq"></pre>
        <acronym id="eawpq"><label id="eawpq"></label></acronym>